Lingenfelter Performance Engineering1557 Winchester RoadDecatur, IN 46733(260) 724-2552 (260) 724-8761 faxwww.lingenfelter.comRevision - 1.1Release da
Page26. Using a 6mm allen socket and blue loctite, install the two (2) M10x1.5x30 at head countersunk bolts (PN: KP82415) that fasten the tensioner
Page29. It there is sufcient clearence under the rear jackshaft pulley, re-install the stock fuel line onto the fuel rail. If there is not enough r
Page33. Lower the tensioner pulley into position. Install the proper set screw for your pulley/belt conguration. There are three different size se
PageLingenfelter Performance Engineering1557 Winchester RoadDecatur, IN 46733(260) 724-2552 (260) 724-8761 faxwww.lingenfelter.comL220160000 L22028000
Page 1. Parts ListLPE Magnuson rear jackshaft bracket kit # Description Part number 1 Rear TVS SC bracket, black anodized XX097
Page2. Additional Required ComponentsOptional Items # Description Part number 2 3.00” 14 rib pulley L220180000 1 70mm 14 rib i
Page3. 2. Using a 1” wrench and 1” socket, break the bolts loose that hold the jackshaft in place.3. Using a 10mm socket, break the rear pulley bolt
Page5. Loosen the rear tensioning screw on the passenger side of the supercharger with a 4mm Allen socket.6. Remove the two (2) rear pulley bracket
Page10. Gently pulling towards the rear of the supercharger, remove the supercharger jackshaft assembly from the forward jackshaft housing.11. Using
Page13. The adjacent illustration shows the LPE supplied rear tensioner bracket and it’s bearing, which will be installed in the following step. Mak
Page18. Using whatever method you choose, pull the end of the jackshaft through the bearing. Again, this operation should not take excessive force t
Page21. For ribbed belts: Install the stainless steel pulley cap (PN: XX09737-0078) onto the M10x1.5x65 bolt (PN: 11516109). Then, install the tensi
Comments to this Manuals