Lingenfelter Performance Engineering1557 Winchester RoadDecatur, IN 46733(260) 724-2552 (260) 724-8761 faxwww.lingenfelter.comRevision - 0.6Release da
Page 9. 8. The illustration below shows the lower half of the EFILive Explorer home screen. With the AutoCal already connected to the computer, the
Page 10. Installing and Removing Calibrations to and from AutoCal1. The EFILive Explorer allows the user to manage the les stored in the internal me
Page 11. Programming a Calibration Using EFILive1. Connect the cable with the RJ45 phone style connector on one end and the automotive diagnostic lin
Page5. Press the down arrow (NEXT) button until you reach the “PROG” options. The Lingenfelter AutoCal has enough internal memory to store up to 5 d
Page 13. 11. When the screen on the AutoCal says “Ignition Off NOW!”, turn the ignition to the off position and press OK. 10. After the original ca
PageLingenfelter Performance Engineering1557 Winchester RoadDecatur, IN 46733(260) 724-2552 (260) 724-8761 faxwww.lingenfelter.comLPE EFILive AutoCal
Page1. Data Logging the Vehicle Data1. Connect the cable with the RJ45 phone style connector on one end and the automotive diagnostic link connector
Page 2. 5. First screen will say “Display DTCs.” This is used to display diagnostic test codes6. Use the right down arrow (NEXT) button to go to th
Page3. 14. And it will then go to the “RECORD DATA” screen15. Press OK to begin recording dataScreen will then display:“CREATING LOG FILE”“STARTING
Page 4. 21. The device will then go back to the “RECORD DATA” screen.22. If you want to record another data log, you can create another recording a
Page 5. 3. The illustration below is the EFILive Explorer user interface. When an EFILive AutoCal is connected to the PC, the AutoCal folder tree sh
Page5. Select the “Scan” folder in the folder tree shown in the last step. This is the default location on the AutoCal where vehicle data logs are k
Page7. Once the data log has been placed on the desktop (or other location), it can now be attached to your email client and sent to LPE.7. Reading C
Page 8. 4. The AutoCAL will power up at this point.5. Press the down arrow button until you reach the “Read” options. The Lingenfelter AutoCal has
Comments to this Manuals